90 Degree V-bit for CNC Routers, 1/4″ Shank [Premium Grade]

(2 customer reviews)

$33.76

Ready for some extremely clean v-grooves with your CNC router?

The only 90-degree v-bit with a knife-edge that actually cuts instead of scraping material away. The 60-degree next-generation “Blade” design virtually ends post-sanding of your v-cuts.

  • Shank: 1/4″ / Length: 2.0″ / Flutes: 2 / Flute length: 0.125″
  • 100% carbide
  • Made in the USA

In stock

Description

The Blade series 90-degree v-bit for CNC routers is designed to shear material from your CNC woodworking projects, not scrape as standard v-bits do.

The Blade is designed with a knife-edge all the way to the point! Not only can you carve to 0.005″ detail, but this CNC router bit actually cuts the wood, leaving a mind-blowing smooth cut. It is a true v-bit!

Most v-bits have a flat edge on them. They scrape the wood away which leaves a rough finish. And unless you want to sand your v-carves, you just might want to invest in this puppy first.

This and all bits on this site are made of 100% solid tungsten-carbide. That’s the material the professionals use because it lasts 50x longer than standard bits.

Even beginner CNC’ers never go back once they use the Blade v-bits!

Made in the USA

Specs

  • Shank: 1/4″
  • Length: 2.0″
  • Flutes: 2
  • Flute length: 0.25″
  • Material: 100% tungsten-carbide
  • Angle: 90°
  • Half-angle: 45°

Settings

  • Feed: 25-40 inches per minute
  • Speed (rpm): 13000-16000
  • For CNCs with routers, use full speed

CNC router Blade v bit for carving…the next generation v-groove v-bit.

Additional information

Weight 1 oz
Dimensions 9 × 7 × .5 in

2 reviews for 90 Degree V-bit for CNC Routers, 1/4″ Shank [Premium Grade]

  1. JP Montei

    I’m not easily impressed by a router bit … until now. This is a true bad a#s bit. I’ve got a Onefinity with T-tracks. I did not place a clamp in the right place and during a rapid move, my router hit a clamp, bent a 1/4 bolt, and this bit chewed it way thru, yes thru!, the bolt and kept going. NO DAMAGE !!!!!

    • garfro3_2skglm

      JP, this is one hell of a testimonial! That’s the way these bits were designed…to take no prisoners! And you just proved it!

  2. Bill

    Fantastic bit, cut my first inlay (with Maple and black Walut) and the fit was clean and tight. This is my go to bit for my vcarving projects.

Add a review

Your email address will not be published.


You may also like…