Ultra-High Detail 3D Carving Taper Ball Nose Bit For CNC Routers, 1/4″ Shank

$27.63

Get your amazing carves going with this taper ball nose endmill router bit for CNC routers. It is designed to give you extremely fine detailed carvings on your CNC router.

The 0.020″ dia. tip cuts every crevice in your 3d CNC project, making that detail POP! Especially when it comes to the resting lion everyone loves to make!

Specs:

  • Shank: 1/4″ (6.35mm)
  • Flutes: 2
  • Length: 2.375″ (55mm)
  • Angle: 10 degrees
  • Ball nose radius: 0.015″ (0.05mm)
  • Feed rate setting: 80-120 in/m (35-47mm/s)
  • RPM: 14,000-18,000

For CNC’s with routers, refer to this PDF download feeds & speeds table

Out of stock

Description

The taper ball nose endmill router bit for CNC routers is designed to give you extremely fine detailed 3D carvings on your CNC router. The broader 10° angle significantly reduces tip deflection common on shallower angled bits, such as 6°, 5°, or less. Tip deflection can deform the fine details of your 3D carve, making the look ‘not quite right’.

Also known as a ‘carving bit‘, the 0.015″ diameter tip cuts every crevice in your 3d CNC project, making the detail pop.

The forward cutting edges allow you to pump up the feed rate while keeping your stepover small. Basically, you get finer detail than other taper ball nose CNC bits while keeping the cuts times the same!

Every CNC wants to make awesome 3d carves. Are you ready to take it on with unparalleled sharpness on your projects?

Order your bit today. By the end of the week, you’ll be carving that resting lion everyone loves to make!

The bit normally used to rough out unnecessary material is the 1/4″ up bit. If you do not have one, you can get your here:

 

Specs: for this CNC router bit.

  • Shank: 1/4″ (6.35mm)
  • Flutes: 2
  • Length: 2375″ (55mm)
  • Angle: 10 degrees
  • Ball nose radius 0.015″ (0.05mm)
  • Material: Tungsten carbide

Settings for your CNC router

  • Plunge rate: 20 ipm
  • Feed rate: 60-80 in/m (35-47mm/s)
  • Stepover: 6-8%
  • RPM: 14,000-18,000

For CNC’s with routers, refer to this PDF download feeds & speeds table

Additional information

Weight .8 oz
Dimensions 9 × 7 × .5 in

Reviews

There are no reviews yet.

Be the first to review “Ultra-High Detail 3D Carving Taper Ball Nose Bit For CNC Routers, 1/4″ Shank”

Your email address will not be published.


You may also like…